Product Catalogue

A single-use clip that brings two tiles to the same plane across the joint. The clear body disappears into the grout line and the break line snaps off flush with the floor.

Driven through the clip and tightened with pliers. Collected when the job is done and used again on the next one.

Cement-based, polymer-modified adhesive. It does not slip on walls, and its long open time gives room to work across a wide area.

Cement-based grout for 1–10 mm joints. A water-repellent additive keeps the surface from staining, and colour holds consistent between batches.

Acetic-cure silicone for wet room junctions. Mould inhibited, and it stays elastic around joints and fittings.

An elastic membrane applied under tiling in wet rooms and on terraces, seamless once cured. Rolled on in two coats, and tiled over directly.

Polyester-reinforced bituminous membrane for foundations and terraces. Supplied in rolls and torched at the laps.

An L trim that protects the tile edge from impact. The anodised surface leaves a clean finish on internal and external corners.

A movement joint for large floor areas. A 304 stainless body with an EPDM insert gives a quiet, lasting junction under load.

A two-component vinylester resin with a mixing nozzle. It carries high tensile loads in uncracked concrete and is used for rebar post-installation.

Pliers made for driving the wedge into the clip. A screw sets the squeeze, so thin tile does not take more force than it should.

A stainless trowel that combs the adhesive to an even bed. Notch size is chosen by tile format.